Heat & CO & Smoke Alarm 1) Power: 9V battery 2) Alarm Volume: ≥85dB@3 m 3) ALarm Pattern: "BI" 0.5s--pause 0.5s--"BI" 0.5s --pause 0.5s --"BI" 0.5s--pause 1.5s, repeat this pattern 4) Alarm Tempearture: 52o C ~ 60o C 5) Operating Conditions: 6) Operating Temperature: -10o C ~ 50o C 7) Ambient Humidity: 10%~ 90% RH 8) Working Currency: ≤80uA 9) Detection Gas Types: CO, SMOKE 10)CO Alarm Sensitivity: Conforms to EN50291 11)Smoke Alarm Sensitivity: Conforms to EN14604

Features: 1)Independent mode: It works as wireless auto smoke and fire (heat )detector alarm. 2)Compatible mode: It works with our burglar alarm system. 3)Widely used for kitchen and no smoking place. 4)Self-detector and automatically give an alarm warning to users. When it works with our burglar alarm, with LED indicated, it sends a wireless signal to alarm host if detecting smoke hydronium. And then it alarms and the alarm host auto-dials the pre-setting telephone or mobile phone 5)Alarm condition required: The smoke density or the temperature with time reaches the limit. Or the "test" button on the detector is pressed. Characteristics Power: 9V, 12V DC Current: Quiescent current of less than 10 mA current police work in between 20 ~ 50mA Smoke sensitivity: Comply with UL Standard 217, alarm temperature limited: 75 C Working Environment Temperature: - 40 C -45 C relative temperature: 10% -90% volume: 85 dB (in 10 feet) Installation Choice suitable place to installing and using two screws to fix the back of the plank on the wall. The detector is a sealed device, and does not allow open, Please put the battery into the battery box or corrected connect all of connecting wire. The detectors will be installed on the two columns on the back of the plank, and a clockwise rotation, convinced that the installation of the two columns have been installed down-detector back