250 MHz PowerPC Processor (350 Mips) Linux Operating System 1 x Smartcard-Reader MPEG2 Hardware decoding Common available NIMs (DVB-S, DVB-C, DVB-T) Tuner modules, Plug&Play V. 24/RS232 Interface 10/100Mbit compatible Ethernet Interface 2 LED status 32 MByte Flash, 96 MByte RAM total Integrated IDE UDMA66 Interface Support for internal HDD 2, 5" in any capacity Unlimited channel lists for TV/Radio Channel-change time < 1 second Full automatic service scan Supports directly bouquet-lists Supports EPG (electronic program guide) Supports own videotext Supports multiple LNB-Switching control (DiSEqC) Fully adaptable OSD in many languages and skin-support S/PDIF Interface for digital bit stream out (AC-3) 1 x Scart-interfaces S-Video connector Analoge modem Technical data DBS-Tuner: Frequency Range 950...2150 MHz Signal Level - 65 dBm...- 25 dBm Signal-to-Noise Level 12 dB max. DBS-Tuner Input Connector F-Type female Input Impedance 75 Ohm AFC +/- 3 MHz Demodulation Shaped QPSK FEC Viterbi and Reed-Solomon Viterbirate 1/2, 2/3, 3/4, 5/6, 7/8, automatic assimilation Roll-off Factor 35 % Demultiplexing according ISO 13818-1 Video decoder: Video Compression MPEG-2 and MPEG-1 compatible Video Standard PAL G/ 25 Hz Video Formats 4: 3 / 16: 9 Footage 16: 9, automatic assimilation for 16: 9 TV-Device (over Scart) Letterbox precolating for 4: 3 TV-Device Audio decoder: Audiokompression MPEG-1 & MPEG-2 Layer I and II Audio Mode Dual (main/sub), Stereo Frequency: 32 KHz, 44.1 KHz, 48 KHz, 16 KHz, 22.05 KHz, 24 KHz Output analog: Output Level L/R 0, 5 Vss on 600 Ohm THD > 60 dB (1 KHz) Crosstalk < -65 dB Output digital: Output Level 0, 5 Vss on 75 Ohm Sampled Data Filtering 32 KHz, 44.1 KHz, 48 KHz S/PDIF-Output optical (AC3) Video parameter: Input Level FBAS 1 Vss +/- 0.3 dB on 75 Ohm Teletext filter in conformity with ETS 300 472 Standard TV-Scart: Output: FBAS, RGB, S-Video Serielle Interface RS 232: Typ RS232 bidirectional Bitrate 115, 2 kBit/s max. Plug Connector SUB-D-9 Function: Update of Firmware Ethernet: 10/100 MBit compatible interface Function: Update of Firmware, Connect to PC UDMA66 IDE Interface: Intern for connect 2, 5" HDD LNB Power and polarisation: LNB Current 500mA max.; Short-circuit-proof LNB Voltage vertical < 14V without load, > 11, 5V at 400mA LNB Voltage horizontal < 20V without load, > 17, 3V at 400mA LNB shut-off at Standby-Mode Count of active satellite position: DiSEqC 1.0/1.2 SAT POSITION / SAT OPTION DiSEqC - Rotor Control Power consumption: < 15W / 12V Input voltage: DC12V, alternating acurrent +/- 15% Extern power supply: Input: 110-240V AC / 50-60Hz / 0, 6A Output: 12V = / 2, 5A Physical specification: Ambient Temperature +15C...+35C Humidity < 80% Size (W x D x H): 195 mm x 130 mm x 40 mm